APW Wyott FD-48H Instructions d'exploitation

RAPW WYOTT Foodservice Equipment CompanyP.O. Box 1829Cheyenne, WY 82003+1 (307) 634-5801 Phone

10If the temperature differential is large than 75ºF, there is probably a problem with your system. It may not be the thermostat. First make sure you

11Heat does not come on Thermostat is bad.when thermostat is turned on. Pilot burner not lit.Gas valve is bad.Pilot burner will not light. Obstruct

12PARTS LISTS & EXPLODED VIEWSGGM GRIDDLES (EXPLODED VIEW)4022161718578112141324223334324441525354526363748492030503924343831929282756129101446471

Pan, Grease 18"Pan, Grease 24"Label, SpecPanel, Back GGM-18Panel, Back GGM-24Panel, Back GGM-36Panel, Back GGM-48Nut, U-TypePanel, ControlPa

56174244674813828GGT GRIDDLES (EXPLODED VIEW)5351596966406012221618578910112141322333586814245215253526556537576149205039245464623463131963292714

GGT (PARTS LIST)Item P/N Description Quan Item P/N Description Qua

16 APW WYOTT EQUIPMENT LIMITED WARRANTYAPW Wyott Foodservice Equipment Company warrants it's equipment against defects in materials and workmansh

CAUTION: These models are designed, built, and sold for commercial use. If these models are positioned so the general public can use

IMMEDIATELY INSPECT FOR SHIPPING DAMAGEAll containers should be examined for damage before and during unloading. The freight carrier has

!!NOTICE: Local codes regarding installation vary greatly from one area to another. The National Fire Protection Association, Inc., states in its NFPA

Caution: DO NOT use an open flame to check for leaks. Check all gas piping for leaks with a soap and water solution before operating unit.THESE UNITS

65. Turn the burner knobs to "HI". If the burner does not ignite, promptly open the pilot valve more. If the pilot flame appears larger than

7CLEANING / MAINTENANCEInitial Cleaning:Prior to operating your new griddle, thoroughly wash the griddle surface and the exterior with

8CONVERSION: Instructions are for conversion from Natural Gas to Propane (L.P.) on all GGT & GGM models .The conversion should be done before conn

GGT CALIBRATION PROBE LOCATION6.42210.645GGT-18GGT-2410.6456.92510.000GGT-3610.6457.92510.00010.000GGT-4810.6457.84410.00012.00010.000CALIBRATION PROC