OPERATING INSTRUCTIONS
1. Turn Main Power Switch on. Set Temperature Control knob to desired temperature. Allow Pilot Light to cycle at least two
times (on/off). When light is on grill is heating. When light is off the grill is off. Time to heat up is about 15-20 minutes.
2. If toasting dry (without oil) insure Teflon sheet is properly installed. Turn motor switch on, conveyor should start to turn.
Place bun halves on feeder cut side down (facing grill surface). Toast time is approximately 14 sec. depending on bun height
and diameter. Increase or decrease temperature setting to achieve desired brownness and temperature.
When toasting using oil, any high-quality cooking oil may be used with this toaster (do not use oils that contain dairy
products such as butter). The Teflon sheet may be used, but is not required. Fill the butter roller 2/3 full of warmed cooking oil.
The oil should spread evenly over the surface of the roller. Holding the bun half in the palm of the hand, slap the cut surface of
the bun on the surface of the turning roller and place the bun half on the feeder cut side down. Try several buns to achieve the
correct pressure and time to achieve the desired browning and temperature of bun. With too little oil the bun surface will be an
uneven color and cool. Too much oil will give the surface a yellow untoasted look. Too much oil may also cause the bun to
stick to the grill.
NOTE: Should the temperature setting be changed, allow several cycles for the grill plate to adjust. Once the desired
setting has been achieved, note the temperature and keep it there.
CLEANING
Turn main power switch OFF. Remove power supply plug from the wall outlet.
Some surfaces will remain hot after toaster is turned off. Allow time for toaster to cool and use caution during disassembly and
cleaning.
To remove butter roller, lift left side of the butter roller shaft out of the collet and remove. To facilitate cleaning, the shaft
assembly may be separated from the cylinder. Hold cylinder securely with one hand and slide the shaft out with the other.
Remove butter pan.
To remove front panels, remove top panel by lifting straight up. Lower panel can now be lifted off.
To remove conveyor, lift conveyor by the handles on both sides and pull towards the front of the unit to disengage gears.
Gear engagement may be tight, if so, push on the chain weights to loosen. Lift the conveyor up and off the hanger brackets.
Conveyor may be hot and is heavy, use caution when lifting and removing.
Remove feeder/Bun Chute and Teflon sheet, if used.
All parts removed may be placed in a dishwasher or sink and washed with detergent and warm water. Lubricate chains with
cooking oil after cleaning.
MAKE SURE GRILL PLATE HAS COOLED, MOISTURE MAY CAUSE BURNS.
Scour grill plate thoroughly using a grill
screen or plastic abrasive pad (Scotch- Brite pads are recommended)
DO NOT USE STEEL WOOL.
It is not necessary to
remove all residue, as long as surface is smooth and free of burned on bread that may cause buns to stick.
Rinse and dry
thoroughly then coat with a light film of cooking oil.
Reassemble.
Feeder
Butter Roller
Butter Pan
Conveyor
Bottom Front Panel
Top Front Panel
PAGE 4
(20 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels